Dramatically increases the life of power transformers
	Increases the dielectric strength and lifespan of the paper insulation, and FR3 or oil in older transformers
	Helps maintain the dielectric strength and DP of the paper insulation, and the dielectric strength of the FR3 or oil in new transformers
	Continually removes moisture from the paper insulation and oil of power transformers using molecular sieve technology to IEEE Standard C57-140-2006, section 7.2
	Uses neither heat nor vacuum maintaining the integrity of dissolved gas analysis
	Keeps new transformers dry, and dries older wet transformers

 

	Complete water to wire packages (15 KW units to 15 MW units)
	Plant and unit upgrades
	Water to wire systems integrator
	Hydro automation systems (SCADA)
	Hydraulic positioners, HPU’s and governors
	All electric (no oil) positioners and governors
	Valve and gate actuator and operating systems
	Self-contained actuator systems (submersible, explosion proof)
	Metering and protection
	Excitation systems
	Switchgear
	AWWA butterfly, ball and cone valves (12" - 120")
	In-line and kidney hydraulic filtration systems
	Hydraulic oil vacuum dehydration systems
	Oil coolers
	Level & remote monitoring/control
	Digital governor conversion systems - Allis Chalmers, Lombard, S. Morgan Smith, Woodward, Sulzer

 

	Substation connector hardware to 500 KV
	AL-AL, CU-CU, and bimetallic AL-CU connectors
	Straight, L, and angle connectors for cable to cable, cable to stud, cable to to flat bus, cable to tube, etc.
	Conductor to insulator supports
	Grounding connectors
	Expansion connectors
	Custom requirements welcomed

 

	Dramatically increases the life of power transformers
	Increases the dielectric strength and lifespan of the paper insulation, and FR3 or oil in older transformers
	Helps maintain the dielectric strength and DP of the paper insulation, and the dielectric strength of the FR3 or oil in new transformers
	Continually removes moisture from the paper insulation and oil of power transformers using molecular sieve technology to IEEE Standard C57-140- 2006, section 7.2
	Uses neither heat nor vacuum maintaining the integrity of dissolved gas analysis
	Keeps new transformers dry, and dries older wet transformers

 

	Transmission line conductor hardware for transmission lines up to 500 KV
	Stockbridge dampers, spacer dampers, conductor spacers, clamps, adapters, preform, yokes, corona rings, etc.
	OPGW and Earthwire accessories
	Charpy compliance

 

	35 -1,000 KVAC, 800 KVDC toughened glass cap and pin, & clevis insulators
	40 - 830 KN (186 kip) AC and 120 KN - 550 KN DC
	CSA C411.1-10

 

	Overhead transmission line conductor
	1,000 kV AC and +/-800 kV DC installations
	ASC, ACSS, ACSR, ACSR/TW, ACCR, etc.
	CSA standards

 

	Pre-molded underground cable accessories to ANSI/IEEE 386 and CENELEC standards
	Underground 600 Amp 28 kV (15/25 KV class) deadbreak elbow connectors
	Underground 200 Amp loadbreak
	Underground 200 Amp deadbreak
	Meets ANSI/IEEE 386 – 2006

 

	Dramatically increases the life of power transformers
	Increases the dielectric strength and lifespan of the paper insulation, and FR3 or oil in older transformers
	Helps maintain the dielectric strength and DP of the paper insulation, and the dielectric strength of the FR3 or oil in new transformers
	Continually removes moisture from the paper insulation and oil of power transformers using molecular sieve technology to IEEE Standard C57-140- 2006, section 7.2
	Uses neither heat nor vacuum maintaining the integrity of dissolved gas analysis
	Keeps new transformers dry, and dries older wet transformers

 

	Silicone deadend insulators 15- 46 kV meeting CEA LW1WG-01
	Polymeric line post insulators 15- 46 kV meeting CEA LW1WG-02
	Kinectrics test reports available